NGon

Create panel > Shapes > Splines > Object Type rollout > NGon

Create menu > Shapes > NGon

Tab panels > Shapes tab > NGon Shape

Use NGon to create closed flat-sided or circular splines with any number (N) of sides or vertices.

Examples of NGons

Procedure

To create an NGon:

Go to the Create panel and choose Shapes.
Click NGon.
Choose a creation method.
Drag and release the mouse button in a viewport to draw the NGon.

Interface

Rendering and Interpolation rollouts

All spline-based shapes share these parameters. See Splines for an explanation of these parameters.

Creation Method rollout

The NGon shape uses the standard creation methods of Center or Edge. Most spline-based shapes share the same Creation Method parameters. See Splines for an explanation of these parameters.

Parameters rollout

Once you have created an NGon, you can make changes using the following parameters:

Radius—Specifies the NGon radius.

Inscribed—The radius is measured from the center to the corners of the NGon

Circumscribed Radius—the radius is measured from the center to the sides of the NGon.

Sides—Specifies the number of sides and vertices used by the NGon. Range=3 to 100.

Corner Radius—Specifies the degree of rounding to apply to the corners of the NGon. A setting of 0 specifies a standard unrounded corner.

Circular—When on, specifies a circular NGon.

Web Designer - offers freelance web design services, redesign, graphic design, content management, web development and e-commerce.
LTD